Has SET, SET COLOR, SET VIBRANCY and SET COLOR TEMPERATURE commands. KETRA DIMMERĭimmer with Level, Color, Vibrancy and Color temperature. Not available in test setup, should work as it is pretty similar to ShadeWithTilt, but was not tested. Shade with Tilt but no Level, has Raise tilt/Lower tilt/Stop tilt functionality, used for Lutron Tilt zones.
Shade with Level and Tilt, has Raise/Lower/Stop functionality and also Raise tilt/Lower tilt/Stop tilt, used for Lutron ShadeWithTiltWhenClosed zones. Shade with Level and Tilt, has Raise/Lower/Stop functionality and also Raise tilt/Lower tilt/Stop tilt, used for Lutron ShadeWithTilt zones. Shade with Level, and Raise/Lower/Stop functionality, used for Lutron Shade zones. Light with on/off functionality, used for Lutron Switched zones. Simple dimmer with Level, used for Lutron Dimmed zones. BUTTON WITH LEDīutton with feedback LED, used for Keypads. BUTTONīutton without feedback, good for Pico controls, but can be used for any Lutron Button.
LUTRON SHADE CONTROL SWITCH DRIVER
This driver intends to overcome this differences but there are some resources that were availableįor testing in one kind of setup and not the other. There are some differences within LEAP between HomeWorks setups and Ra2 Select/Caseta setups, Resources from connected system, all supported devices connected to your Lutronīridge should show up to be added. Under the Resources menu, press the Import resources button and then Load To add resources it is recommended to use the import resources functionality. Status and there should appear a message asking you to press the mentionedīutton, but giving it a couple of seconds should be enough.Īfter another couple of seconds the connection status should become green.
You can check the logs hitting the system connection To connect to a Lutron device add the system and set the IP address at theĬonnection settings, after a couple of seconds press the device button toĪuthorize BLI to connect. LEAP development is ongoing so only those devices and features already supportedīy the protocol at the time of developing this driver are supported. LEAP is the protocol used to integrate Lutron RA2 Select, Caseta and HomeWorks Lutron RA2 Extensible Application Protocol (LEAP)
0 kommentar(er)
